Hks Evc 6 Manual Pdf

Turn the knob left to switch to boost mode A and turn right to the mode B. It may cause damage to the engine.

Dirt build up in the air filter can cause unstable boost control which may lead to engine damage. Make sure there are no parts that have loosened after stopping the engine. Make sure there is no excessive stress on hoses or harnesses.

The digital display L stops blinking and the speed display will then blink. For extra boost, the scramble boost feature will add a users specified amount of boost over the current boost setting for a preset duration between seconds. When the selection has been made, press the volume knob.

Photos 4 5 6

This function is user selectable to be on or off. Press volume knob to complete setting. The basic hose layout procedure is similar as the swing valve.

Follow the procedure below for the initial setting. After confirming that it is closed, press the volume knob to set the value. It features negative yellow backlight, where the backlight is black, and the foreground is yellow. This optional oil-resistant hose is available separately.

To ensure that the throttle is completely closed, step on the accelerator pedal and then release. Make sure all splices are the included ones and stalked properly. It is recommended to mount the display unit to a position where it is lower than your eyes or mount the unit facing upwards.

When the code is selected, press the volume knob again to set. Also, the boost is lowered to the stock value or a preset value to prevents damage to the engine. It may cause damage to the vehicle. Dirt build up may cause an inability to control boost, which may cause damage to the engine.

Photos 1 2 3

HKS EVC 6 Manual

Related titles

If not, drive the vehicle under load to achieve the maximum boost value. Make sure all hoses are not damaged. When the value is selected, press the volume knob again. Drive the vehicle to reach the max boost.

After selection has been made, press the volume knob to set value. After confirming that it is fully open, press the volume knob to set the value. Installation should be performed by a professional. It may cause damage to the electronic parts.

Warning -Risk of severe injury or death may result if warning is not acknowledged or followed. Make sure hoses and harnesses are secured properly. Make sure the negative cable terminal is securely attached to the battery. Make sure wiring is done correctly.

This completes the initial setting. After selectioning, press the volume knob. Failure to let the engine cool can lead to severe burns. Warning If the boost exceeds the warning value, an audible beep and visible warning display notify the user. Press the volume knob after the selection.

The digital display L stops blinking and the throttle setting will blink. When the settings are done, press the volume knob. After the selection, press the volume knob to set.

The multi- display also enables simultaneous data recognition. Or, the boost creep or drop is due to an increase in the exhaust pressure. When the set value in each mode is blinking, pressing this button switches the mode group.

Make sure the boost control solenoid valve is bypassed. Simultaneously, it lowers the boost to the baseline boost value or by a user preset value.

ELECTRONICS

Refer to the Optional Parts list in this manual. Retain this instruction manual for later reference. Prior to installation and use, network protocols map pdf thoroughly read the instruction manual. And somehow it works via powerwriter software.

Or, the boost creep or drop is due to the actuator incapacity. Make sure all connectors and splices are connected securely. The value will then be shown in the digital display S. Actual installations may vary depending on the vehicle application. Consult an authorized dealer immediately.

Installation should be performed by a professional

An optional remote scramble boost trigger is available to supplement the trigger button on the headunit for Scramble Boost activation. The basic hose layout procedure is the same as for the swing valve type. When selection is done, press the volume knob again.

When the selection is made, press the volume knob to set. Drops boost to the baseline boost value. After selection is done, press the volume knob. After selections, press volume knob. This ensures more precise setting.